Type Full Name :
Sign With Hand
(F) Floor Area Ratio (%)
Address *
Address *
(A) Lot Area (sq ft)
Fax #
{[CNAME]}
(H) Setback from property lines (Min 6 ft) *
(D) Total Coverage (B + C) (%)
Description of Proposed Shed *
Property Owner Details
EXISTING
Applicant Signature *
Proper Zoning Review requires the completion of the data sheet. The “Proposed” column should include the NEW parameters which would result from building the NEW shed(s).
(A) Lot Area
This is the actual square footage of the lot.
(B) Building Coverage
This is square footage of the land area covered by buildings or other structures with roofed areas.
  • Residences
  • Garages, Sheds, Porches
  • Decks, Cabanas, etc.
(C) Other Impervious Coverage
This is the square footage of all other impervious surfaces other than that created by Building Coverage.
  • Driveways and other paved areas
  • Patios & walkways, tennis * basketball courts, areas with interlocking "paver" stones, etc.
  • Surface area of swimming pools, decks which do not allow free drainage of rainwater through to the ground underneath.
(D) Total Coverage
The sum of B and C is, in fact, the total impervious surface area. The maximum is determined using the formulas under 270-62. This value should be inserted into the center column of row D in the above chart.
(E) Gross Building Floor Area
The square footage of all enclosed floor areas of buildings on the property.
  • Residences - all floors excluding open porches, unfinished attics, basements, decks or patios
  • Garages and accessory buildings (sheds, etc.)
(F) Floor Area Ration (F.A.R.)
Allowable F.A.R. is defined by the Code. Calculate existing and proposed by dividing existing and proposed gross building floor area, respectively, by lot size.
Email *
Phone # *
(G) Shed Height (ft) (Max 9.5 ft peak)
Select the Address where the Shed is to be erected *
PROPOSED
{[ADDR]}
{[CITY]}, {[STATE]} {[ZIP]}
{[APHONE]}
{[AWEBSITE]}
Email *
(E) Gross Building Floor Area (sq ft) (GBA)
Name *
Amount Due:
{[PNAME]} Application
Description of Proposed Base and Anchoring for Shed *
General Requirements for Sheds
Lot *
MAX/MIN/REQ’d or ALLOWED
Shed Details
(C) Other Impervious Coverage (sq ft)
Applicant Details
Phone # *
Name *
Attach Required Documents
Sheds with an area of two hundred (200) square feet or less and an average height not exceeding ten (10) feet do not require a construction permit but do require a Zoning Approval permit.

Sheds with an area greater than two hundred (200) square feet require Zoning Approval as well as a Construction Permit. The shed is to be mounted on a base of at least four (4) inches of crushed stone or an equivalent mounting surface. It must be securely tied down to prevent wind from disturbing the installation. Inspection upon completion is required.

Sheds must be at least six (6) feet from side and rear property lines and must meet the front setback requirements for the zone. Sheds must also be at least ten (10) feet from any principal building.

Consideration should be given to the fact that Sheds impact the Building Coverage as well as Gross Building Floor Area which are parameters governed by Borough Zoning Ordinances. The following information is from the Zoning Ordinances.

(1) A property survey prepared in the last eight (8) years showing the location of the shed is required for review
(2) A complete set of construction drawings and/or manufacturers’ specifications of the shed is required
(3) The Zoning Data Table (above) must be completely filled out or application will be rejected

Zoning Data Table *
Block *
(B) Building Coverage (sq ft)
City, State, ZIP *